Preparation and Inspection before Daily Startup:
1. Stop vehicle at flat ground with parking brake.
2. Pull out dipstick
3. Wipe it with clean cloth, then insert it again down to the bottom.
4. Pull out the dipstick again and check the oil level.
5. Check the oil level and confirm whether it is between upper and lower mark on the dipstick; if it is
below the lower mark, add the oil required.
Notice
1. The oil level check shall be carried out after shutdown for 15～20min.
2. Check the water tank coolant is enough, and add properly if required.
3. Check oil tank for shortage and add properly if required.
4.Check the pipelines and joint faces for oil and water leakage.
5. Confirm the parking brake is in working.
6. The engine should be in the empty load condition.
To Next Page
Loading...