Replacement Procedure of Coolant Fluid in Engine
Open both drain plug and radiator cap.
Open the drain valve on the engine block.
Tighten the water switch on the block after drainage of coolant fluid.
Fill water into the radiator
Keep the engine at the speed of 1600-2000rpm for about 1 minutes to vent air.
Shut down and repeat the step 2 to 4 two to three times.
Add coolant fluid into the radiator to specified level.
Carry out the proportion of antifreeze fluid and water in accordance with the description attached
to the container for antifreeze fluid.
To Next Page
Loading...