To Next PageTo Next PageHow to troubleshoot a motor that doesn't work on AGT INDUSTRIAL Lifting Systems?
If the motor of your AGT INDUSTRIAL Lifting System isn't working, there are several potential causes: * The air switch might be faulty. Try turning it off or replacing it. * The voltage might be incorrect. Ensure you're using the correct power supply. * The motor, start switch, top limiter switch, or AC contactor might be burned out, requiring replacement.
What to do if the motor works but AGT INDUSTRIAL AGT-B1000 can't lift?
If the motor in your AGT INDUSTRIAL Lifting System is running but the system isn't lifting, consider these possibilities: * The pressure valve pressure may be too small. Adjust the pressure valve clockwise for fine adjustment. * The pump station may be taking in air. Unscrew the check valve on the power unit and start the motor until hydraulic oil flows out, then tighten the check valve. * The hydraulic oil suction hose might be detached or broken. Install or replace the suction hose. * There might be insufficient hydraulic oil. Fill the system with more hydraulic oil.
Why is there a loud motor noise in AGT INDUSTRIAL Lifting Systems?
A loud motor noise in your AGT INDUSTRIAL Lifting System can be due to several reasons: * If the motor continues to run after reaching the highest point and the top limiter switch is disabled, replace the top limiter switch. * Hydraulic oil might be polluted, requiring replacement. * The system may be overloaded. Note that this operation is prohibited.
What to do if AGT INDUSTRIAL Lifting Systems raise without load, but doesn’t raise with load?
If your AGT INDUSTRIAL Lifting System raises without a load but fails when loaded, check these potential causes: * The voltage may be too low. Install a voltage stabilizer. * There might be objects in the dump valve. Remove any obstructions. * The pressure valve pressure may be too small. Increase the pressure properly by fine-adjusting the pressure valve. * The system might be overloaded. Note that this operation is prohibited.
What to do if AGT INDUSTRIAL AGT-B1000 does not lowering?
General| Brand | AGT INDUSTRIAL |
|---|---|
| Model | AGT-B1000 |
| Category | Lifting Systems |
| Language | English |
