PROCEDURE
GEN 1 (2) : Reset, then ON. If generator
does not remain ON, set switch
to OFF. Power is supplied to all
loads by the remaining genera-
tor.
GEN BUS 1 (2) : ON, check.
CAUTION
Check ammeter does not exceed limits.
Failure of generator bus#1or#2
(Helicopters not equipped with emergency bus)
This failure is indicated by the BUS TIE caution message on EDU 1.
PROCEDURE
GEN BUS 1 or 2 : ON. If engagement of one
switch trips the other, reengage
the tripped switch and reset
other switch to OFF.
If failure confirmed, no loads are lost.
Failure of both generator busses
(Helicopters not equipped with emergency bus)
This failure is indicated by the BUS TIE caution message on EDU 1.
PROCEDURE
RFM A109E
R.A.I. Approved 3-47
Rev. 16
To Next Page
Loading...