PROCEDURE
GEN 1 (2) : Reset, then ON. - If #1 (#2) DC
GEN caution light remain ON,
select switch to OFF (loss of
generator).
GEN BUS (1 and/or 2) : ON. If engagement of one
switch trips the other, reengage
the tripped switch and reset
other switch to OFF (loss of
affected bus).
NOTE
If both switches remaining engaged, power is supplied to all loads
by remaining generator.
CAUTION
Check ammeter does not exceed limits.
Failure of both generators
(Helicopters not equipped with emergency bus)
This failure is indicated by #1 and #2 DC GEN caution messages on EDU 1.
PROCEDURE
GEN 1 and 2 : Reset, then ON.
If both generators are inoperative, continue flight on battery
Land as soon as possible.
GEN BUS 1 and 2 : ON, check.
RFM A109E
R.A.I. Approved 3-48C
Rev. 19
To Next Page
Loading...