NOTE
When use of search and landing light is required proceed as
follows:
LDG LT switch : FWD.
SCHLT switch : ON, extend and set as
necessary.
CAUTION
Landing light operation shall be limited to the time strictly
necessary to carry out takeoff and landing manoeuvres in order to
avoid overheating.
Takeoff area : Check clear.
Collective : Slowly increase to hover at ap-
proximately 3 ft (1 m) wheels
height and note torque.
Altimeter : Set zero pressure altitude.
ADI : Adjust (if applicable) the pitch
bar to indicate zero.
NOTE
When taking off in windy conditions, set the ADI and the
baro-altimeter on ground allowing for the anticipated attitude and
altitude changes.
RFM A109E
APPENDIX 12
Page 18 of 88 E.A.S.A. Approved
Rev. 39
To Next Page
Loading...