Ahlborn ALMEMO 2290-4 V5 - Initial Operation

2. INITIAL OPERATION
1. Connect transducers to the sockets M0 and M1 (2), see 4.
2. Ensure power supply with 9V battery or mains adapter, see 3.1, 3.2.
3. For switching on move the slide switch (1) on the left side of the unit to the
upper position, see 3.3.
4. For displaying the measured values:
select function MEAS. VALUE with key M/
HOLD (6),
select the measuring channels with key M▲, read the meas. values, s. 7.1.1.
5. For cyclic output of measured values to printer or computer:
connect peripheral device via interface cable to socket A1, see man. 5.2,
set 9600 bd, 8 data bits, 1 stop bit, no parity at peripheral device, see 9.1,
enter correct time and date, as required, see 7.3.2,
use the key F1 to select the function PRINT CYCLE ´PC´ and program the
print cycle, see 7.3.1,
use key M▲ to select the output format in function BAUDRATE ´BR´, s. 9.2,
use key START/
STOP to start and stop the cyclic measuring point scan, s. 7.3.
6. For storing the measured values (only with option S):
use the key F1 to select the function PRINT CYCLE ´PC´ and program the
print cycle, see 7.3.1,
enter correct time and date, as required, see 7.3.2,
use key START/
STOP to start and stop the recording of measuring data, s. 7.3.
For output of memory data to printer or computer:
connect peripheral device via interface cable to socket A1, see man. 5.2,
set 9600 bd, 8 data bits, 1 stop bit, no parity at peripheral device, see 8.1,
use key M▲ to select the output format in function BAUDRATE ´BR´, s. 9.2,
use key START/STOP to output measured values in function ´MF´, see 7.4.3.
7. For evaluating the measurement:
use key F1 to select the function MAX VAL ´MH´ or MIN VAL ´ML´ and recall
the max and min values, s. 7.1.3.
ALMEMO

2290-4 11
Initial Operation