If the key is pressed for longer than one second a digit or an
▲
PROGR
abbreviation will flash in the display, i.e. the instrument is in edit mode and the
red designations below the keys are valid. Then, the keys +/-, ▲, ▼ are
available for changing the input digit, the key operates as cursor key
▲
PROGR
and CLEAR is available for clearing the parameters The data input is finished
when the last digit has been confirmed by operating the key .
▲
PROGR
5.4 Data Entry
The programming of numeric parameters is performed as follows:
Selection of the function by using the function keys F1 or F2...
or
The programming is started by long pressing the
key . The first programmable digit
▲
PROGR
flashes and can be altered.
The digit can be increased using the key ▲ .
After exceeding the maximum value the cycle restarts from zero.
The digit can be decreased using the key ▼ .
After falling below zero the maximum value follows (9 or 5).
The sign can be changed using the key ± .
+/-
A switch to the next digit is performed using the key .
▲
PROGR
PROGR
To switch back to previous digit the key must
▲
PROGR
be pressed long.
1s
PROGR
The programming process is complete
after setting the last digit and again operating the key
▲
PROGR
PROGR
Programming and measured values can be cleared using ,
1s
PROGR
CLEAR
F2F1
1s
PROGR
ALMEMO
2290-4 21
Display and Keypad
To Next Page
Loading...
