Switch-off, i.e. deactivation of a programmed measuring channel
Function: RANGE ´R´ Keys: ,
1s
PROGR
CLEAR
After switch-off the measured value is no longer indicated, queried or provided
as output. However, the programming is still maintained.
Re-activation of the measuring channel:
Function: RANGE ´R´ Keys: ,
1s
PROGR
PROGR
If the channel was previously deactivated, it will be re-activated with all
programmed values. However, if the channel is already active then all
programming values will be cleared by operating the above key combination
(corresponds to selecting a measuring range).
6.3 Changing the Dimension
Each measuring channel allows replacing the standard dimension of the
measuring range by any other dimension that has two digits (see manual 6.3.5).
In addition to all capital and normal letters, the characters , Ω, %, [, ], *, -, =,
,
~and spaces (_) are available. The dimension is indicated by two 16-segment
characters that are indicated following the measuring and programming values.
The change of the dimension can be performed within the function MEAS.
VALUE by long
pressing the key . The first character of the
▲
PROGR
dimension will flash in the display. It can then be changed by using the keys ▲
and ▼. When the first character is selected the key should be
▲
PROGR
pressed and the same procedure will be performed for the second character.
When the desired dimension has been set the programming can be completed
by the key .
▲
PROGR
Function: MEAS.VAL.
, ... , , ... ,
1s
PROGR
PROGR PROGR
1st dim change 2nd dim change end
When the dimension °F is entered a temperature value in degrees
Celsius will be converted into degrees Fahrenheit.
The cold junction compensation can be switched off by using the
characters C or F.
The dimension ms is indicated on the display as m/s, and mh as
m
3
/h.
ALMEMO
2290-4 25
Sensor Programming
To Next Page
Loading...
