Ahlborn ALMEMO 2590-2A - 11.5 User measuring menu U1 data logger

11. Measuring menus
32
functions by pressing key(s)
<F> :  or  ...
This reduces the maximum number of channels to 6.
To advance to the next function press key (s)
<F> : 
Measured value with designation
Meas points list designation
00: 23.12°C temperature
Measured value with maximum value
Meas points list Max. value
00: 23.12 °C 32.67 °C
Measured value with minimum value
Meas points list Min. value
00: 23.12 °C 19.34 °C
Measured value with average value
Meas points list Aver. value
00: 23.12 °C 25.45 °C
Measured value with limit value, maximum
Meas points list Limit val max.
00: 23.12 °C 32.67 °C
Measured value with limit value, minimum
Meas. points list Limit val min
00: 23.12 °C 19.34 °C
Measuring range only (also maximum 12 channels)
Meas. points list Range
00: NTC °C
For more than 6 measuring points select the next
page by pressing key(s) PROG , <M▲> or <M▼> ...
11.5 User measuring menu U1 data logger
User menu U1 can be freely configured by the
user using the ALMEMO
®
-Control software (see
11.6). A data logger menu is provided as standard.
This menu can be used either on its own or just
like any measuring menu in conjunction with the
function menu
Data logger functions
( see 12.5 ).
The device status is displayed by certain symbols in the status bar (see 9.2).
Data acquisition can be set to cyclic via the
cycle timer
. The available memory
is displayed in the function
memory capacity free
. This is omitted if neither
internal memory nor a memory connector is available. The menu can then be
used for output via the interface to a computer.
To start a cyclic measuring operation (if cycle >0) : <START> see 12.5.5
To initiate manual measured value scanning (if cycle =0) : <MANU> see 12.5.4
Example of a configured user measuring menu Bar chart
Or alternatively e.g. a user menu
Bar chart
could
be configured using the ALMEMO
®
-Control soft-
ware (see 12.5). With the functions ´measured
value, small´ and ´bar chart´ 2 channels with
measured value and bar chart diagram can be
shown.