EasyManua.ls Logo

Aico Ei161RC User Manual

Default Icon
2 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
Model Ei161RC
Dual Ionisation chamber sensor
Tamper proof rechargeable Lithium battery back-up
Easi-fit base
Remote Control capability
Built in Test/Hush button
Advanced suppression and calibration technology
Interconnectable to other Ei mains powered alarms
Low power cell warning
Kitemarked to BS EN14604:2005
5 Year Guarantee
Product Description
The Ei161RC is an Ionisation Smoke Alarm that runs on 230V AC
mains power, and has built in tamper proof Lithium cells that act as
a battery back up in the event of mains failure. These rechargeable
Lithium cells are designed to have a ten-year life and outlast the life
of the smoke alarm itself, whilst providing up to six months of
smoke alarm operation without mains power.
The alarm gives a fire warning when adequate smoke enters the
alarm.
The alarm is supplied with the Easi-fit base that allows very quick
and simple installation of the smoke alarm, combined with simple
alarm head removal and replacement. The Easi-fit base automatically
connects both mains power and battery as the detector slides on.
The alarm allows the detector to be controlled remotely by either a
“Test, Silence and Locate” Switch (Ei1529RC) or a Manual Call Point
(MCP401RC). If the alarm is also connected to other Ei ‘RC’ mains
powered alarms then the whole system can be controlled remotely.
Up to 20 alarms can be interconnected.
The alarm has other advanced features such as built in circuitry to
aid suppression of voltage transients and RF interference to further
reduce the chances of false alarms under such conditions.
Operation
The green indicator will illuminate to show mains power is
present
The red indicator will flash every 40 seconds to show that the
detector has performed an automatic self test
The red indicator will flash rapidly to show an alarm condition
for the alarm that has triggered
The “Test/Hush” button will either silence false alarms (if
briefly pressed) or to perform a self test (if pressed and held)
In “Test” mode the alarm will perform a self test and sound the
horn
In “Hush” mode the alarm enters a ten-minute period of
reduced sensitivity to overcome false alarm conditions. It will
then automatically reset itself
When interconnected to other Ei mains powered alarms, an
alarm on one detector will trigger all other interconnected
alarms (only the triggered alarm will flash a red indicator)
The smoke detector will emit a beep every 40 seconds to
indicate that the battery backup is depleted and needs
recharging
Mains Powered 230V~ with
Rechargeable Battery Back-up
Ionisation Smoke Alarm
E & OE Our policy is one of continuous improvement. Ei161RC DataSht Rev2 08.11.10
We reserve the right to amend designs and specifications without prior notice.
Mile End Business Park, Oswestry, Shropshire SY10 8NN Tel. 0870 758 4000 Fax. 0870 758 4010 www.aico.co.uk
Question and Answer IconNeed help?

Do you have a question about the Aico Ei161RC and is the answer not in the manual?

Aico Ei161RC Specifications

General IconGeneral
BrandAico
ModelEi161RC
CategorySmoke Alarm
LanguageEnglish

Related product manuals