2.6 Custom turret and custom turret ring
The custom turret allows an operator to customize the sight by creating elevation
settings to adapt to any ballistic prole.
Preparations
a Put the custom turret ring on the custom turret.
b Install the assembled custom turret and custom turret ring to the sight by following
instructions in 2.3.
c Perform zeroing in accordance with instructions in 2.4. When zeroing, ensure that the
custom turret and custom turret ring is set to its starting position (”A” / Fig. 6).
d Loosen and remove the spring lock with the T10 Aimpoint tool. Alternatively, use the
hex key socket on the drill tool guide to loosen the spring lock (”B” / Fig. 6)
e Install the drill guide to the sight as shown in "C" / Fig. 6. The drill tool guide ensures
that the drill does not damage the turret when creating a mark.
To Next Page
Loading...
