Why I cannot start my Air Cleaning Equipment Dehumidifier?
If you cannot start your Air Cleaning Equipment Dehumidifier, there might be a couple of reasons. First, the air filter could be clogged, so clean the filter mesh according to the instructions in the manual. Second, the air inlet or outlet might be jammed. If so, clear any blockage from the air inlet or outlet.
How to fix a loud noise coming from my Air Cleaning Equipment Dehumidifier?
If your Air Cleaning Equipment Dehumidifier is making a loud noise, it could be due to a couple of reasons. First, the machine might not be level; if this is the case, move it to a flat and firm ground. Second, the filter mesh might be jammed; in this case, clean the filter mesh according to the instructions in the manual.
What does flashing red light mean on my Air Cleaning Equipment Dehumidifier?
If your Air Cleaning Equipment Dehumidifier is showing a flashing red light, this indicates a temperature sensor issue. Check to ensure the wire is connected at both ends. If the wiring looks good, the sensor itself may be faulty.
What does E1 error code mean on my Air Cleaning Equipment Dehumidifier?
If your Air Cleaning Equipment Dehumidifier is displaying the trouble code E1, this indicates a humidity sensor issue. Check to ensure the sensor wire is connected at both ends. If the wiring appears to be properly connected, the sensor itself may be faulty.
General| Brand | Air Cleaning Equipment |
|---|---|
| Model | Horizon Galaxy |
| Category | Dehumidifier |
| Language | English |
Ensure the unit is placed on a level surface for proper operation.
Instructions for attaching and routing the drain line for water discharge.
Controls the unit's on/off state and indicates power status. Fan runs for 3 mins after off.
Adjusts the target indoor humidity level upwards in set increments.
Adjusts the target indoor humidity level downwards in set increments.
Shows indoor humidity level or selected setpoint, returning to indoor humidity after adjustment.
Indicates the unit is plugged in and ready to operate. Should be off during service.
Illuminates green when the unit is set to continuous operation mode.
Glows red when the unit is in defrost mode, clearing ice buildup from the evaporator coil.
Instructions for powering on the unit and setting the desired humidity setpoint.
Procedure for stopping the machine, noting the fan's post-operation run time.
Details on automatic draining and procedures for draining before moving or storing the unit.
Use a soft damp cloth to clean the exterior. Do not use solvents.
Instructions for unplugging, disassembling, cleaning, and reinstalling the filter mesh.
To Next Page
