55
OPERATION
These errors appear on the cooking top display.
Error code Description Possible causes Solution
ashing
Continuous activation
of one or more keys. The
control turns o after 10
seconds.
Liquids or cookware on
the control zones.
Clean the control zone or
remove the cookware.
U 400
Input current > 300 V.
The control unit shuts
down after 1 second,
emitting a continuous
beep.
Incorrect connection.
Contact the authorized
technical support centre
and specify the error
code.
E2 Hob overheated.
Hob overheated
(cooking with empty
pots)
Output heat on sensors
> safety level.
Cool down the hob; the
error disappears after
cooling.
If the error persists,
contact the authorized
technical support
centre and specify the
error code.
Er20, Er22, Er31, Er36, Er47,
E5, E6, E9
Problems due to
hardware, software or
power supply.
Hardware errors detected
Contact the authorized
technical support centre
and specify the error code.
TABLE OF COOKING TOP ERRORS
(Warning: burn hazard!!!) Lastly, clean the cooking zone when it has cooled.
The symbols on the cooking top can wear out as a result of using abrasive or aggressive detergents,
steel wool, and the scraping of pots and pans. Avoid using these cleaning products. In any case,
this will not in any way compromise the unit’s correct operation.
Note: all of the problem issues described in this section are solely of an aesthetic nature and do not
in any way aect the appliance’s correct operation. They cannot be restored under the warranty.
To Next Page
Loading...