Air Lift WirelessONE 25870 User Manual (English)

Other manuals for Air Lift WirelessONE 25870

Questions and Answers:

J
Jesse CantuJul 27, 2025
What to do if my Air Lift Air Compressor system does not maintain or reach ride height?
- T
  Tiffany WilsonJul 27, 2025
  There are a couple of potential reasons why your system isn't maintaining ride height. First, there might be a large leak in the system. Locate and correct the leak as described in Finding Air Leaks and Fixing Leaks in Barbed Fittings and Fixing Leaks on PTC Fittings. Remove and reinstall the 15A fuse to reset the fault. Second, the vehicle could be overloaded. If the air pressure in the system is at its max pressure of 100 PSI (7BAR), the system will stop inflating.
S
smithdianeAug 6, 2025
What to do if my Air Lift Air Compressor system does not exhaust when deflation is commanded?
- T
  Thomas BarnesAug 6, 2025
  If your system isn't exhausting when deflation is commanded, the following could be the cause: * Check the vehicle battery. It might be too low (below 9 volts) or too high (above 18 volts). * The manifold temperature might be too cold; allow it to warm up. If it's too hot, allow it to cool down and move it away from heat sources.
C
Catherine DelacruzAug 11, 2025
Why does my Air Lift Air Compressor run often without commanding an inflate adjustment?
- B
  Brenda DiazAug 11, 2025
  A small air leak in the system could be the cause. You should locate and correct the leak. See Finding Air Leaks and Fixing Leaks in Barbed Fittings and Fixing Leaks on PTC Fittings and Fixing Leaks on Braided Stainless Steel Air Lines for detailed instructions.
S
stephaniebradleyAug 16, 2025
What to do if nothing happens when making an adjustment with the remote of my Air Lift WirelessONE 25870?
- A
  Amber McknightAug 16, 2025
  When first powering on the wireless controller, the Bluetooth connection is established in the background. Changes to the desired pressure can be made while connecting, but the adjustment command won’t be sent until the Bluetooth connection is complete and signal strength icon is visible in the upper left corner of the screen. Wait for the Bluetooth connection to complete. The last adjustment will automatically be made once the connection is established.
J
Joseph ColonAug 21, 2025
What to do if nothing happens when the vehicle is turned on with my Air Lift WirelessONE 25870?
- G
  gbellAug 22, 2025
  If the ignition wire is not connected, the system will only maintain a preset if the vehicle starts moving or is connected to the wireless controller or mobile app. Connect the optional ignition wire if desired. Connect to the manifold using the remote or mobile app to wake the system up for quicker adjustments.