Air Techniques VacStar 50 User Manual

This kit includes:
PART NUMBER DESCRIPTION Quantity
30920 Lock Washer, 1/4” 3
55142 Separator Drain Hose Assembly w/ Elbow 1
55981 Exhaust Hose Assembly w/Teflon 1
55499 Eductor Assembly for VS80 w/Bracket 80H 1
55498 Eductor Assembly for VS50 w/Bracket 50H 1
55147 1/2” Poly flow tubing, 14” 1
55231 1/4” Poly flow tubing, 17-1/4” 1
30822 Bolt 1/4-20 x 1/2” Hex Head 3
30711 Screw; 10-24 x 1/2” Hex Head Washer 2
55264 Hose and Cuff Assembly 1
49833 Hose Clamp 2
56006 HydroMiser Assembly w/ Bracket & Water System VS80 1
57278 1” Rubber Coupling (incl. with HydroMiser Assy) 1
56005 HydroMiser Assembly w/Bracket & Water System VS50H 1
55927 Adapter Fitting, 1” MNPT x 1” Barb 1
HYDROMISER INSTALLATION KIT
INSTRUCTIONS
PN 56041 for VacStar 50 (VS50)
PN 56042 for VacStar 80 (VS80)
Tools needed for this installation:
 7/16” Wrench  5/16” nut driver  Philips screw driver  Cutter  Tape Measure
 Adjustable Pliers
Review the FLOW DIAGRAM, below, before beginning installation.

Air Techniques VacStar 50 Specifications

General

Brand	Air Techniques
Model	VacStar 50
Category	Water Pump
Language	English

Summary

Prepare the Vacstar to Receive the Hydromiser Assembly

Disconnect Water Distribution System

Steps to disconnect the water distribution system, including tube measurements and removal of distribution systems from the back rail.

Remove Exhaust Hose and Fitting

Instructions for removing the existing exhaust hose and fitting between the exhaust manifold and the drain.

Install Hydromiser Assembly, Eductor, Reattach Tubing

Install Eductor and Connect Poly Flow Tubing

Steps for installing the eductor block and connecting the poly flow tubing from pumps and water distribution system.

Attach Hydromiser Assembly to Back Rail

Procedure for attaching the Hydromiser assembly to the back rail of the VacStar using bolts and lock washers.

Connect Poly Flow Tubing to Hydromiser Assembly

Connecting the 1/4" and 1/2" poly flow tubes to the water distribution system and the Hydromiser assembly.

Connect Exhaust Hose and Drain/Vent Assemblies

Attach the Exhaust Hose

Steps for screwing the exhaust hose assembly into the exhaust manifold and connecting it to the Hydromiser assembly.

Connect the Drain Hose Assembly

Connecting the drain hose assembly to the drain outlet and the building drain, adhering to local codes.

Connect Hose and Cuff Assembly

Connecting the Hose and Cuff assembly to the Hydromiser assembly and the building vent using hose clamps.

Check Out Procedure

System Test and Eductor Mode Adjustment

Procedure to check for leaks, test the unit, and set the eductor to recycle and bypass modes to verify installation.