EasyManua.ls Logo

airdeer A1 - Page 4

Default Icon
9 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
If the voice prompts: "Failed bag loading, please check if the garbage bag is used up or
broken." please lift the flip lid manually and check whether the garbage bag is broken.
If the garbage bag has a rupture, but the rupture is relatively small, this section of the
garbage bag can still be used. You can manually press the garbage bag to the bottom of
the can and continue to use it.
If the garbage bag rupture is relatively large, this section of the garbage bag cannot be
used. Please manually press the garbage bag to the bottom of the can, and then carry
out the operation of packing and loading the bag again. For details, please refer to
Section 4 of the manual "Automatic Packing and Loading the Bag".
If the garbage bag is not broken after inspection, it is usually because the newly installed
refill ring is too tight, resulting in unsuccessful bag loading. Please manually press the
1.5.
Turn the power switch on the back
of the trash can from the left side to
the right side,that is, from the OFF
position to the ON position. The
trash can will load a bag automati-
cally, and then the voice prompt
"Bag loading is complete".
1.4.
01
Remove the bag cabin lid
02
Put in the new refill ring
03
Compress the Refill ring
all around
Bag cabin
04
Put on the bag cabin lid
05
Pull the stitching thread
all out