Aire SK Series User Manual

INSTALLATION INSTRUCTIONS
SINGLE SPLIT WALL MOUNTED AIR CONDITIONER
More than
10cm
More than 70cm
More than
60cm
More than
10cm
Gas side piping
Liquid side piping
Additional drain pipe
Vinyl tape (Narrow)
Connecting cable:
Cooling & Heat pump: 2EA
Cooling only: 1EA
,,,
,,,
,,,







yyy
yyy
yyy
zzz
zzz
zzz
{{{
{{{
|||
|||
1. Type "A" screw
2. Installation Plate
3. Type "B" screw
4. Holder Remote Control
Air filter
(Left and right
are identical)
Installation plate
Sleeve
Bushing-Sleeve
Putty(Gum Type Sealer)
Bend the pipe as closely
on the wall as possible,
but be careful that it
doesn't break.
Installation parts you
must purchase
Vinyl tape (Wide)
• Apply after carrying out a
drainage test.
• To carry out the drainage
test, remove the air filters
and pour water into the heat
exchanger.
Saddle
More than
5cm
More than
5cm
P/No. : 3828AR7314S
(SK-Series)
• Please read this instruction sheet completely before installing the product.
• When the power cord is damaged, replacement work shall be performed by authorized
personnel only.
• Installation work must be performed in accordance with the national wiring standards by
authorized personnel only.
Installation Parts Provided
• This illustration is for explanation purposes only.
The indoor unit will actually face a different way.
ENGLISH ITALIANO ESPAÑOL FRANÇAIS DEUTSCH

Aire SK Series Specifications

General

Type	Split System
HSPF Rating	Up to 10
Refrigerant	R410A
Voltage	208/230V
Power Supply	1 Phase, 60Hz
Features	Inverter Technology
Operating Temperature (Cooling)	62°F - 90°F
Operating Temperature (Heating)	5°F - 75°F
Coefficient of Performance (COP)	Varies by model (e.g., 3.5)

Summary

Safety Precautions

Critical Warnings and Cautions

Details critical warnings and cautions for safe installation and operation.

Selecting the Best Location

Indoor Unit Location Requirements

Guidelines for choosing a suitable location for the indoor unit.

Outdoor Unit Location Requirements

Guidelines for choosing a suitable location for the outdoor unit.

Piping Length and Elevation Limits

Specifies maximum permissible piping length and elevation differences.

Installing the Mounting Plate

Mounting the Installation Plate

Drilling the Wall Hole

Flaring Work Procedures

Performing Flaring

Indoor Piping and Drain Hose Connection

Connecting Indoor Pipings

Indoor Piping Connection Details

Tightening Flare Nuts

Finalizing Indoor Unit Piping Connections

Indoor Unit Installation onto Plate

Outdoor Piping Connection

Aligning and Tightening Outdoor Pipings

Outdoor Unit Installation

Connecting Indoor and Outdoor Unit Cables

Indoor Unit Cable Connection

Connecting the power cable wires to the indoor unit's control board terminals.

Outdoor Unit Cable Connection

Connecting the power cable wires to the outdoor unit's control board terminals.

Circuit Breaker Recommendation

Checking the Drainage and Forming Pipings

Checking the Drainage

Procedure to verify the indoor unit's drain hose functionality and detect leaks.

Forming the Piping

Air Purging Procedures

Air Purging Overview

Leak Test with Nitrogen

Procedure for leak testing the system using dry nitrogen gas and soap water.

Evacuation and Finishing Job

Evacuation Process

Guide to evacuating the system using a vacuum pump to remove air and moisture.

Finishing the Job

Test Running Procedures

Settlement of Outdoor Unit

Steps for securely anchoring the outdoor unit to its mounting base.

Performance Evaluation

Checking system performance by measuring pressures and temperatures.

Pump Down Procedure

Instructions for collecting refrigerant into the outdoor unit for relocation or service.