Airfree E40 - Handling and Maintenance Safety

6
Always keep Airfree
®
in its vertical position as shown in the picture.
Do not attempt to use it sideways, under furniture, or with its bottom air
inlets and or outlets blocked avoiding air to ow in and sterilised air to ow
out Airfree
®
. If any of the above occurs, the TSS
™
ceramic core will be
disconnected as the unit will not work properly in those conditions and after
about 1 minute, the anti-stress light (exclusive in models P40/P60/ P80/P125/
P150) will start blinking to call for attention, indicating poor installation, or
eventual malfunctioning. After few seconds of being properly installed the
anti-stress light will stop blinking.
Do not attempt to open Airfree
®
or touch its internal components and/ or do not
insert any objects as it may pose electric shock.
Any attempt to open or tamper Airfree
®
will void this warranty.
To clean Airfree
®
, unplug it from the electric outlet and use a dry cloth to wipe
off its surface. Do not attempt to open Airfree
®
to clean it inside.
Only Airfree
®
authorized dealers have the expertise and authorization to re-
pair your Airfree
®
.
In the event of a return for repair, make sure Airfree
®
is well protected
preferably inside its original box to avoid further damage
Airfree
®
nearest dealer may be seen at www.airfree.com
If the supply cord is damaged, it must be replaced by the manufacturer,
its service agent or similarly qualied persons in order to avoid a
hazard.
Safety
Instructions