Airlink101 LX60 User Manual

AirLink LX60
Hardware User Guide
41111782
Rev. 2

Airlink101 LX60 Specifications

General

Wireless Standards	IEEE 802.11b/g
Frequency Band	2.4 GHz
Ports	4 x 10/100Mbps LAN, 1 x 10/100Mbps WAN
Security	WEP, WPA, WPA2
Wireless Data Rates	Up to 54 Mbps

Summary

Important Notice

Safety and Hazards

Limitation of Liability

Patents

Copyright

Trademarks

Contact Information

1: Introduction to the LX60

Key Features

Lists the primary capabilities and connectivity options of the LX60 router.

Description

Sample Power Consumption Scenarios

Accessories

Warranty

2: Installation and Startup

Tools and Materials Required

Lists necessary tools and materials for setting up the LX60 router.

Installation Overview

Provides a step-by-step guide to the typical installation process for the LX60.

Step 1—Insert the SIM Card

Step 2—Mount and Ground the LX60 Chassis

Step 3—Connect the Antennas

Recommended Antenna Separation

Step 4—Connect the Data Cables

Step 5—Connect the Power

Cable Strain Relief

Fusing

DC Voltage Transients

Power Connector on the LX60

Wiring Diagrams

Fixed Installation

Fixed Installation with I/O Input Triggered by Standby Mode

Vehicle Installation Considerations

Connect the Router to the Vehicle's Electrical System

Vehicle Installation: Option 1

Vehicle Installation: Option 2

Step 6 (Optional)—Connect the Vehicle Bus Cable

7: I/O and RS Configuration

I/O Pins

Details the pin configurations for Auxiliary I/O and Power connectors.

Pulse Counter

Digital Input

High Side Pull-up / Dry Contact Switch Input

Analog Input

Low Side Current Sink Output

Digital Output/Open Drain

Step 8—Check the Router Operation

LED Behavior

Ethernet LEDs

9: Configure the Software

Configuring with ACEmanager

Instructions for accessing and using the ACEmanager interface.

Configuring with AirLink Management Service

Overview of remote management using AirLink Management Service (ALMS).

Configuring with AMM

Configuring with AT Commands

Reboot the LX60

Reset the LX60 to Factory Default Settings

Recovery Mode

3: Specifications

Certification and Interoperability

Lists certifications and interoperability standards for the LX60.

Included Radio Module Firmware

Network Technology

Reliability

Environmental Testing

Host Interfaces

Antenna connectors

Describes the types and locations of antenna connectors on the LX60.

USB

Details the USB port functionality, modes, and driver requirements.

Ethernet

Specifies the Ethernet port capabilities, speed, and standards.

Serial Port

RS485

SIM Card Interface

Mechanical Specifications

Screw Torque Settings

Operating Voltage

Power Specifications

GNSS Technology

Protocols

Wi-Fi Performance

Wi-Fi Channels Supported

Wi-Fi Antenna Gain

Radio Frequency Bands

Radio Module Conducted Transmit Power

GNSS Bands supported

Mechanical Specifications

4: Regulatory Information

Important Information for North American Users

FCC compliance and user guidance for North American installations.

RF Exposure

Maximum Antenna Gain

WEEE Notice

A: Accessories

DC Power Cable (Black Connector)

AC Power Adapter (Black Connector)

AC Power Adapter Input

AC Power Adapter Output

AC Power Adapter Environmental Specifications

AC Power Adapter Reliability and Quality Control

AC Power Adapter Safety Standards

AC Power Adapter EMC Standards

AC Power Adapter Hazardous Substances

AC Power Adapter Energy Efficiency

I/O Connector Cable