AIRSYS UNICOOL 28V1B5 - Page 83

System Parameters and Default Values
83
The Debug and Hardware Configuration Menus contain configuration options for all controller modules.
Settings changed here from the controller box will not carry over to the individual units. No password is required
to access these options.
Note: The Debug Menu should not be accessed outside of initial startup or system update unless directed by
AIRSYS Support or the site technician. To enter the Debug Menu, press Up and Down at the same time from
the main screen.
Table 5-17 Debug Menu Options
Menu Screen
Option
Description
Master/HVAC
Select
Master/HVAC
Select between Master and HVAC controller operation
Conversion
Unit Conversion
Change between different unit systems
Operation Mode
(Unit Only)
Operation Mode
Select between normal and fixed speed operation
Work alone mode
Work alone mode
Set up unit for operation without an ASMUC.6 controller
To enter the Hardware Configuration Menu, hold Alarm and Enter at the same time until the menu is displayed.
Table 5-18 Hardware Configuration Menu Options
Menu Screen
Option
Description
Information
PCO Info
Control software information
I/O Info
HW and SW version information
Memory Info
System RAM Usage
pLAN Info
System pLAN address
Filesystem Info
System Storage Info
Tasks Info
System Tasks Information
Application Info
Current system status
Built In Info
Built In Info
Settings
Password
Change password
Connections
Allow USB, PC, and pCO disk connections
pLAN pCO address
Change pCO address
Clock
Change time or sync to server
TCP/IP Settings
Change IP address and settings
Application
Application settings
Reboot controller and controller OS options
Upgrade
Upgrade
Upgrade OS
Logger
Logs
Export, wipe, restart system logs
Diagnostics
System Logs
View system logs