Need help?Do you have a question about the Airwell AWPO-MAF009-C11 and is the answer not in the manual?
General| Brand | Airwell |
|---|---|
| Model | AWPO-MAF009-C11 |
| Category | Temperature Controller |
| Language | English |
Instructions to prevent injury and property damage during operation.
Warnings related to electrical work, grounding, and installation safety.
Cautions regarding refrigerant leakage, drain hose, and operational safety.
Detailed technical specifications for the Airwell Portable MAF Series models.
Information on refrigerant type (R410A) and charge amount.
Overview of operating modes, optional functions, and unit features.
Identification and layout of buttons and indicators on the control panel.
Physical dimensions of the Airwell Portable MAF unit.
Illustration and explanation of the refrigeration system's cycle and components.
Electrical schematic showing component connections and layout.
Definitions of technical terms like TC, TA, TS, and TE.
Specifies the required input voltage for the unit's operation.
Details safety features like compressor delay and anti-icing protection.
Requirements and operation for the fan-only mode.
Operational logic for the cooling mode, including fan and compressor control.
Operational parameters and conditions for the drying mode.
Operation of fan and heater in optional heating mode.
Operation of compressor, motors, and valves in heat pump mode.
Error codes (E2, E1, E4, E3, P1) and their corresponding sensor faults.
Identification of major internal components like evaporator, compressor, and fans.
Details of the display board, sensors, motors, and power connections.
Shows locations of fan motor capacitor and electronic control box.
Procedures for removing, cleaning, and reinstalling air filters.
Guidance on cleaning the exterior surfaces of the unit.
Steps for preparing the unit for storage when not in use.
Methods for testing compressor wiring, ground, and overload.
Procedures to check compressor efficiency and terminal overload issues.
Lists essential equipment for sealed refrigeration system repairs.
General procedures for repairing refrigerant leaks and component replacement.
Detailed steps for replacing hermetic compressors and system handling.
Procedures for motor burnout, system flushing, and rotary compressor service.
Correct procedures for charging refrigerant into the system.
How to test the fan motor for proper operation and speeds.
Methods for testing the compressor and fan motor capacitors.
Table of temperature sensor resistance versus temperature values.
Common problems, causes, and suggested remedies for unit issues.
Detailed list of part numbers and names for the models.
To Next Page
