OPERATION
OPERATION
Set vertical vanes to the front position during
COOLING/DRY operation if humidity is high.
If the vertical vanes are set to the left-most
or right-most position, condensation will form
around the air outlet and drip off.
Do not move the ap with your hands when the
air conditioner is running.
NOTES
The ap automatically closes when the unit is
off.
During the heating operation, the fan speed
will be very low and the flap will be in the
horizontal position until the air being blown
out of the unit begins to warm. Once the air
warms up, the flap position and fan speed
change to the settings specified with the
remote control.
Use the FLAP button on the remote control to
adjust the position of the flap. If you move the
flap by hand, the factual flap position and the
ap position on the remote control may no longer
match. If this should happen, shut off the unit,
wait for the flap to close, and then turn on the
unit again; the flap position will now be normal
again.
Do not have the ap pointed down during cooling
operation. Condensation may begin to form
around the air vent and drip down.
ADJUSTING THE AIR FLOW DIRECTION
HORIZONTAL (manual)
The horizontal air ow can be adjusted by moving
the vertical vanes to the left or right, as indicated
in the following gures.
VERTICAL (with remote control unit)
The remote control gives you the possibility to
control the ap in two way:
Push the button to start the flap sweep. If
you push again the ap stops immediately.
7
To Previous Page
Loading...
