Airwheel H3T - User Instructions: Initial Setup; Unpacking and Motor Lock Adjustment; Joystick Installation and Wiring; Main Power Activation

- 3 -
After completing the above steps, turn on the power. The main power
switch and charging port are located behind the battery compartment
(Picture3-1).
3.Turn on the main power
1-1 1-2
3-1
User Instructions:
Hand mode
Electric
mode
Tie rod of
clutch
Open the wheelchair carton, take out the wheelchair and place it
gently on the  oor, then take out the accessory box at the rear of
the wheelchair (see Picture1-1) and remove the cardboard near
the motor lock. Turn the motor lock to drive mode (see Picture1-2).
Contents in the paper box: a Charger, controller, user manual,
plastic tie and assembling tools etc.
1.Take out the accessory box at the
rear of the wheelchair
Charging port
Main power
switch
The joystick could be installed on the left or right armrest freely, accoridng to user's habit
①
Fix the joystick groove with screw and tighten the screw (Figure 2-1)
②
Insert the joystick into the groove and tighten the screw. (Figure 2-2)
③
Connect the wires and  x the wires with cable tires.(Figure 2-3)
2.Install the joystick
2-1 2-2 2-3
The joystick groove
The joystick
assembly
The joystick wiring
Screw