- 14 -
Front fender
Water brush (optional, if any)
Align the front water brush and
the round hole in the rear water
brush to the circular holes in
front and rear wheels. Tighten it
with screw and nut.
Fender (optional, if any)
Align the front fender and
rear fender to the circular rod
holes in front and rear wheels.
Tighten the front fender with a
screw and nut and rear fender
with wrench.
Storage rack (optional, if any)
Align the round holes (above
and below) in the storage rack
to the round holes in the saddle
and rear wheel. Tighten the top
part of the storage rack with
screw and the lower part with
screw and nut.
Front water
brush
Front wheel
Rear wheel
Front water brush Rear water brush
Storage rack
Rear water brush
Front wheel
Front fender Rear fender
Rear fender
Rear wheel
To Previous Page
Loading...
