Aiwa TP-60R - User Manual

move. ‘T'P-6GOR
SERVICE MANUAL
AIWA CO.. LTD. Tokvo, JAPAN
1. Disassembly
a.
After
removal
of
batteries,
unfasten
four
set
screws,
two
on
each
side
of
the
case
as
indicated
by
the
crrow
merk
in
Fig.
1.
Then,
pressing
the
record
button
located
on
the
side
(also
arrow-
marked),
push
the
tape
deck
out
of
the
case
in
such
a
wey
tact
the
portion
where
the
bcttery
compcrtment
is
located
may
come
out
first
(see Fig. 1).
| Fig. 1 |
2.
The
Set
Fails
to
Operate
Completely
(Fig. 2)
The
remote
jack
is
the
smallest
of
the
three
jacks
coming
in
a
row.
o. Defective contact of the remote jack:
The
set
will
not
operate
when
this
jack
fails
to
make
contact
with
each
other
at
the
point
indicated
by
the
arrow
mark
in
Fig.
2.
The symptom typical of this trouble
is that whereas the set operates with
the microphone plug inserted in‘o this
jack and the remote switch turned on,
the set fails to operate when the plug
is pulled off. Check if the lead wire
is broken.
b. Defective contact of push button (Fig. 3):
Such occurs when the segment plates, A and B do not come in
contact with each other even in Play or Rewind position. To remedy
this defect, bend B somewhat in the direction indicated by the arrow
merk in Fig. 3.
c. Defective motor (Fig. 4):
If the reel platform does not revolve in Play or Rewind position
while yet all other parts are found normal, it indicates the defective
motor, which should be replaced.
Use a screwdriver
to unfasten screw.
Fig. 4
d. No operation on battery power supply. Or very slow in re-
volution speed:
The above symptom indicates the worn-out or excessively weak-
ened battery, which must be replaced immediately.

Aiwa TP-60R Specifications