After Sales Support
(AU) 1300 886 649 (NZ) 0800 836 761 | info@tempo.org
17
Door Reversal (Cont.)
Door installation
Follow the illustration in Fig. 2, below, to reinstall the door onto the other side, using
the parts you removed earlier.
• Remove the hole cover plate (7)
covering the upper hinge holes.
• Before replacing the lower
hinge (2), remove the bolt pin
(9) and reverse the direction of
the lower hinge (2).
• Install the lower hinge and the
front leg (2) onto the left side of
the lower frame with the three
screws (8).
• Insert the bolt pin (9) to the
lower hinge (2).
• Secure the door onto the lower
hinge.
• Holding the door in the closed
position, secure the upper
hinge (5) on the top left hand
side with the three screws (1).
NOTE: Do not fully tighten the
screws (1) until the top of the
door is level with the top of the
unit.
• Install the upper hinge cover (6)
on the upper hinge.
Fig. 2:
Door opening from the right side
To Next Page
Loading...