Akai AM-59

Recording
Before proceeding
e Turn on the power of all components. ¢ When connecting components for tape dubbing:
e ‘fusing a DAT deck for recording, set it for analog recording. The TAPE 1 and 2 terminals are for connection of the source
deck or recording deck.
The TAPE 3 terminals are for connection of the recording
deck only.
STEREOINTEGRATED AMPLFER AM-00
| Select the recording source with the REC OUT SELEC- 9 Pi z
TOR
switch
as
follows:
Wi
folariceladtare
Migt-me-rere)celiale|
For
broadcast
recording:
To
monitor
the
sound
of
the
source
being
recorded,
select
the
.
Select
TUNER.
source
with
the
input
selector
buttons.
For
record
disc
recording:
if
the
tape
deck
you
are
using
to
record
on
has
3
heads,
you
can
Select
PHONO.
monitor
the
actual
sound
that
is
being
recorded
by
pressing
the
For
CD
recording:
input
selector
button
that
corresponds
to
the
recording
deck
you
Select
CD.
wish
to
monitor.
For auxiliary source recording:
Select LINE
For digital source recording (AM-69 model oniy):
Select DIGITAL 1/2/3 and then press the DIGITAL SELEC-
TOR 1, 2o0r3 button depending on which digital terminal the
source component is connected to.
For tape dubbing:
Select TAPE COPY 1 -— 2/3 when recording from a cas-
sette deck or DAT deck connected to the TAPE 1 terminals.
For tape dubbing:
Listening to another source during -
ixcterelael tale)
If you wish to listen to another source during recording, simply
select that source with the input selector buttons. Recording will
not be interrupted.
To adjust the sound of the selected source (using the VOLUME,
Select TAPE COPY 2 -> 1/3 when recording from a cas- BALANCE, BASS, TREBLE, MODE or MUTING controis), set
sette deck or DAT deck connected to the TAPE 2 terminals. the SOURCE DIRECT switch to OFF (SUBSONIC) before rec-
. ording. Signals being recorded will not be affected by adjust-
2 After adjusting the recording level of the cassette deck ments.
or DAT deck, start recording.
Note:
After recording is finished: © During recording do not change the position of the REC OUT
Set the REC OUT SELECTOR switch to OFF and turn off the SELECTOR switch as this will interfere with recording.
power. e For AM-69 model: During digital source recording, do not
change the DIGITAL 1, 2 or 3 input selector button setting as
this will interfere with recording.
11