Akai AM-59

Source playback
Before proceeding
e Set the VOLUME control to 0.
© Set the MUTING switch to OFF.
@ Set the REC OUT SELECTOR switch to OFF.
© Turn on the power of ail components.
After
the
amplifier’s
power
has
been
turned
on,
the
protection
circuit
will
be
engaged
for
a
few
seconds.
The
amplifier
can
not be operated during this time.
indicators
Sampling frequency | ii
| Set the SPEAKERS switch to the desired position as
follows.
If you have connected speakers to the A terminals:
Set the switch to the A position.
If you have connected speakers to the B terminals:
Set the switch to the B position.
if you have connected speakers to both the A and B ter-
minals:
Set the switch to the A+B position.
2 Set the SOURCE DIRECT switch to DIRECT or OFF
(SUBSONIC).
3 Select the playback source with the INPUT SELECTOR
as follows:
For broadcast reception:
Select TUNER
For record playback:
Select PHONO
For CD playback:
Select LINE
For playback of a cassette deck or DAT deck connected
to the TAPE 1, 2 or 3 terminals:
Select TAPE 1, 2 or 3
For digital source playback (AM-69 model only):
Select DIGITAL 1/2/3 and then press the DIGITAL SELEC-
TOR 1, 2or3 button depending on which digital terminal the
component is connected to.
4 Play back the selected source.
STEREO WTEGAATED AMPLFER AM-60
5
Adjust
the
playback
volume
with
the
VOLUME
controi.
Sampling frequency indicators
(AM-69 model only)
The
sampling
frequency
indicators
light
up
during
digital
source
playback
to
indicate
the
source’s
sampling
fre-
quency.
The sampling frequency is an important frequency necess-
ary
for
digital
to
analog
signal
conversion
during
playback.
‘The
standard
sampling
frequencies
are
48kHz,
44.1kHz
and 32kHz.
*
The
44kHz
indicator
will
light
up
during
44.1kHz
samp-
ling
frequency
source
playback.