Akai AT-K02

TECHNICAL DATA
POWER AMPLIFIER SECTION
RATED OUTPUT POWER
2-CHANNELS DRIVEN
26 watts per channel, minimum RMS, at 8 ohms from 20 to 20,000 Hz
with no more than 0.01% total harmonic distortion. __
POWER BANDWIDTH (IHF)
___6 Hz to 60 kHz/8 ohms (Total harmonic distortion: 0. 1%)
SIGNAL TO NOISE RATIO (IHF)
PHONO
Better than 75 dB
Better than 95 dB
RESIDUAL NOISE One oe
CHANNEL SEPARATION (IHF)
__ Less than 0.5 mV at 8 ohms _ -
_____ PHONO | Better than 55 dB at 1,000 Hz _ : Z
DAMPING FACTOR - More than 4S(1kHz,8 ohms) er
OUTPUT SPEAKERS A, B (4 to 16 ohms)/A+B (8 to 16 ohms)
_HEADPHONE _ 4 to 16 ohms
PRE AMPLIFIER SECTION
INPUT SENSITIVITY/IMPEDANCE
PHONO
AUX
TUNER
TAPE MONITOR
__DIN: 150 mV/100 kohms
OUTPUT LEVEL/IMPEDANCE
TAPE REC
PRE OUTPUT
_1V/) kohm
3 mV/47 kohms
150 mV/100 kohms
150 mV/100 kohms
PIN: 150 mV/100 kohms
PIN: 150 mV/1 kohm
DIN: 30 mV/30 kohms
FREQUENCY RESPONSE
PHONO (RIAA EQUALIZATION)
TUNER, AUX, TAPE MONITOR,
30 Hz to 15 kHz +0.5 dB, -0.5 dB
10 Hz to 40 kHz +0 dB, —? dB
TONE CONTROL BASS +8.5 dB at 100 Hz
TREBLE +8.5 dB at 10 kHz
LOUDNESS CONTROL 1: +3 dB at 100 Hz, +2.5 dB at 10 kHz
2: +6.5 dB at 100 Hz, +5.0 dB at 10 kHz
3: +10 dB at 100 Hz, +9.5 dB at 10 kHz
__._. ... (Volume control set at —30 dB position) _ = - _
FILTER HIGH —3 dB at 10 kHz
eed! _SUBSONIC_ —3 dB at 18 Hz ; _
MISCELLANEOUS
SEMICONDUCTORS _ Transistors: 16, Diodes: 19, ICs: 9
POWER REQUIREMENTS
120 V, 60 Hz for U.S.A. and Canada
220 V, 50 Hz for Europe except UK and Australia
240 V, 50 Hz for UK and Australia
110/220/240 V, 50/60 Hz pwitchable for other countries
POWER CONSUMPTION _. 40oW : pee
DIMENSIONS : 440 (W) x 105 () x 300 (D) mm (17.37 x 4.1" x 11.8")
WEIGHT
—1
7.8
kg
(17.2
Ibs)
* For improvement purposes, specifications and design are subject to change without notice.
16