Akai AT-K02

1. TECHNICAL DATA
FM TUNER SECTION
FREQUENCY RANGE | |__87.5 MHz to 108 MHz _
SENSITIVITY (IHF) : 19 yV oan =
CAPTURE RATIO _ ; 1.2 dB ack
SELECTIVITY (IHF) - ____._ More than 65 dB _ er 8 en
IMAGE REJECTION More than60dB(98MHz) ee
IF REJECTION _ _ More than 85dB(98MHz) a
SPURIOUS REJECTION ' More than 85 dB (98 MHz)
AM SUPPRESSION me _ 60 dB -
SIGNAL TO NOISE RATIO ! 73 dB
HARMONIC DISTORTION. = =MONO | Less than 0.09% (100% modulation)
= a _ STEREO _|_Less than 0.12% (100% modulation)
TUNING INDICATOR ; 3 LEDs
SIGNAL INDICATOR "5 LEDs i
MUTING - — \_ Switchable to ON-OFF - a
STEREO SEPARATION » More than 52 dB (1 kHz) 7 _
SUB CARRIER SUPPRESSION More than 60 dB
OUTPUT VOLTAGE ~ "Fixed 1 V (100% modulation) pa
ANTENNA INPUT IMPEDANCE __ 300 ohms balanced, 75 ohms unbalanced -
AM TUNER SECTION
FREQUENCY RANGE | 520 kHz to 1,605 kHz
SENSITIVITY (IHF) | _150 pV/m (bar antenna), 10 pV (external antenna) a
SELECTIVITY (IHF) __ More than 30 dB 7 ae
IMAGE REJECTION "More than 55 dB (1,000 kHz) 7
IF REJECTION _ - More than 40 dB a -
SIGNAL TO NOISE RATIO More than 55 dB >
OUTPUT VOLTAGE «300 mV (30% modulation)
ANTENNA a Built-in ferrite barantenna epee
MISCELLANEOUS
SEMICONDUCTORS Transistors: 26, Diodes: 13, LED: 6, ICs: 4
POWER REQUIREMENTS ' 120 V, 60 Hz for U.S.A. and Canada
220 V, 50 Hz for Europe except UK
240 V, 50 Hz for UK and Australia
a 110/220/240 V, 50/60 Hz internally switchable for the other countries
POWER CONSUMPTION — 20W 7 ; ;
DIMENSIONS ; 440 (W) x 78 (H) x 340 (D) mm (17.3 x 3.1 x 13.4) inches
WEIGHT _ 4.9 kg (10.8 Ibs) _
* For improvement purposes, specifications and design are subject to change without notice.