Akai AT-K02 - Page 8

V. VOLTAGE CONVERSION
110V AREAS: FI 400mA
220V AREAS: F2 200mA
240V AREAS : F3 200mA
POWER TRANS
ATKO2T-70
Models for Canada, USA, Europe, UK and Australia are
not equipped with this facility.
Each
machine
is
preset
at
the
factory
according
to
destination but some machines can be set to 110V,
220V or 240V as required.
If
voltage
change
is
necessary,
this
can
be
accomplished
as follows.
1) Disconnect AC Power Cord.
2) Loosen holding screws and remove upper case.
3) Remove existing line voltage fuse in proper fuse
holder, explicitly following instructions printed
on the rear panel.
Fig. 4 Fuse Holder (A) (U/T Model)