Akai AT-K11/L

V. VOLTAGE CONVERSION
1. MODEL AM-U11
POWER SWITCH
POWER SWITCH
P.C BOARD
Fig. 7 Voltage Conversion (U/T Model Only)
This machine can be set to 110—120 V, 220 V or 240 V
as required. Each machine is preset at the factory ac-
cording to destination. However, if voltage change is
necessary , this can be accomplished as follows:
2. MODEL AM-U22
1. Disconnect Power Cord.
2. Loosen holding screws and remove upper cover.
3. Remove Line Voltage wire and fit onto proper pins,
explicitly following the printed instructions.
POWER
TRANSFORMER
110V AREAS: FI 2.5A 250V
220V AREAS: F2 L25A 250V
240V AREAS : F3 1.25A 250V
FRONT SIDE
Fig. 8 Voltage Conversion (U/T Model Only)
Models for Canada, U.S.A., Europe, UK and Australia
are not equipped with this facility.
Each machine is preset at the factory according to desti-
Nation but some machines can be set to 110 V, 220 V,
or 240 V as required.
If voltage change is necessary, this can be accomplished
as follows.
1) Disconnect AC Power Cord.
2) Loosen holding screws and remove upper cover.
3) Remove existing Line Voltage Fuse and insert required
Line Voltage Fuse in proper fuse holder. Follow
markings explicitly.
36