Akai AT-K22/L

V. VOLTAGE CONVERSION
REAR PANEL _/7%) a CI has
if
A
HOV AREAS:FI O4A 250V
220V AREAS:F2 0.2A 250V
Cor
240V
AREAS:F3
02A
250V
3
C]
F2
1
sR oe
:
:
FRONT SIDE
Fig 7 Voltage Conversion (U/T Model Only)
Models for Canada, U.S.A., Europe, UK and Australia
are not equipped with this facility.
Each machine is preset at the factory according to desti-
nation but some machines can be set to 110 V, 220 V,
or 240 V as required.
If voltage change is necessary, this can be accomplished
as follows.
i! 1) Disconnect AC Power Cord.
2) Loosen holding screws and remove upper case.
3) Remove existing Line Voltage Fuse and insert required
Line Voltage Fuse in proper fuse holder. Follow
markings explicitly.