Akai GX-265D

PINCH WHEEL SOLENOID MICRO SWITCH SW-9
(A)
. POSITION ADJUSTMENT OF PINCH
WHEEL SOLENOID SL-3 (Refer to Fig. 1)
1) Remove head block.
2) Insert a 4.2 mm gauge (a U type washer etc.)
between the P Plunger Lever and P Joint (Refer
to Fig. 2).
3) Set the deck to playback mode and fix Pinch
Wheel Solenoid at position at which the pinch
wheel begins to rotate.
. PINCH WHEEL POSITION ADJUSTMENT
AT STOP MODE (Refer to Fig. 3)
1) Remove head block.
2) Adjust Stopper so that the clearance between
Pinch Wheel and Capstan Shaft is 9.5 mm.
. PINCH WHEEL PRESSURE ADJUSTMENT
(Refer to Fig. 2)
Adjust Pinch Wheel Pressure Adjustment Nut so that
pinch wheel pressure is 1.3 to 1.4 kg.
. POSITION ADJUSTMENT OF PLAY HOLD
MICROSWITCH SW-11 (Refer to Fig. 3)
Adjust Play Hold Microswitch position so that at
stop mode, the Play Hold Microswitch operates
properly and the Slide does not contact the body
of the microswitch.
QT MICRO SWITCH SW-I6
QUICK PLATE
CAPSTAN
Fig. 3
5. SLIDE ADJUSTMENT (Refer to Fig. 3)
Adjust part (A) of the Slide so that at stop mode, the
Pinch Wheel Solenoid Microswitch operates properly,
and part (A) does not strongly hit against the body
of the microswitch.
. POSITION ADJUSTMENT OF QUICK
PLATE (Refe to Fig. 3)
Adjust Quick Plate position so that at stop mode,
the Quick Tension Microswitch operates properly,
and the Quick Plate does not strongly hit against the
body of the microswitch.
. POSITION ADJUSTMENT OF RECORDING
MICROSWITCH SW-S (Refer to Fig. 1)
Adjust part (A) of the Slide so that at playback mode
the Recording Microswitch operates properly, and
part (A) does not contact the body of the micro-
switch.