5.7.2 If the battery is out of service for a long time, please
store it after full charge. W h e n the battery discharges
automatically, please replenish it once a month.
5.7.3 When repairing , please protect the lead of the hub
in case of damage (axle end). The lead of five signal lines
of brushless motor can not be short connected,
otherwise the sensor inside the motor will be damaged.
5.7.4 Avoid placing in humid air, high temperature and
corrosive gas, and avoid operation failure and chemical
corrosion on the surface of electroplating paint for metal
parts.
5.7.5 Avoid frequent starting of vehicles, otherwise the
life of batteries, motors and controllers will be shortene d.
5.7.6 If there are problems with charger, controller,
battery and motor, please do not disassemble without
authorization. Please come to our designated
maintenance station for maintenance and treatment.
5.7.7 When cleaning plastic parts, w ash them with soft
cloth or sponge and neutral detergent, ge n tly wipe off the
stains, and then rinse them repeatedly with clean water
and dry cloth.
When cleaning alloy parts, in order to prevent residual
detergents from corroding alloy parts, clean and dry
them with clean water, and then coat them with
appropriate anti-rust oil. If the vehicle passes through
acid, alkali and grease areas, the tire should be cleaned
in time to avoid aging or wear.
After cleaning, lithium grease should be used to lubricate
moving parts (front axle, shock absorber, pivot).
It is strictly forbidden to use high-pressure water gun to
To Next Page
Loading...