Akuvox A02 Administrator's Guide

Akuvox A02 Access Control Terminal Admin Guide
www.akuvox.com
49
19.4 Action URL
A02 allows you to set up specific HTTP URL commands that will be sent to the HTTP
server for the predefined actions. Relevant actions will be initiated if there occurs any
changes in the relay status, input status, PIN code, and RF card access for security
purpose. You can navigate to the Setting > Actions URL.
Akuvox Action URL:
11
Tamper Alarm
Triggered
$alarm status
Http://server ip/
tampertrigger=$alarm status
No
Event
Parameter format
Example
1
Make Call
$remote
Http://server ip/
Callnumber=$remote
2
Hang Up
$remote
Http://server ip/
Callnumber=$remote
3
Relay Triggered
$relay1status
Http://server ip/
relaytrigger=$relay1status
4
Relay Closed
$relay1status
Http://server ip/
relayclose=$relay1status
5
Input Triggered
$input1status
Http://server ip/
inputtrigger=$input1status

Akuvox A02 Specifications

General

Interface	Ethernet
Case design	-
Event capacity	100000
Number of users	20000 user(s)
Card holders quantity	20000
Maximum number of doors	1 door(s)
Supported network protocols	IPv4, HTTP, HTTPS, FTP, SNMP, DNS, NTP, RTSP, RTP, TCP, UDP, ICMP, DHCP, ARP
Ethernet LAN data rates	10, 100 Mbit/s
DC voltage range	12 V
Power consumption	600 mA
Ethernet LAN (RJ-45) ports	1
Storage temperature (T-T)	-30 - 70 °C
Operating temperature (T-T)	-20 - 55 °C
Operating relative humidity (H-H)	10 - 90 %

Weight and Dimensions

Depth	33 mm
Width	86 mm