Aladdin MAXbrite Burner Operating and Safety Instructions – November 2016 2 | P a g e
6. Put the gallery-mantle assembly in a sink or on some other non-combustible surface. Light a match and hold it near
the top of the mantle fabric. This will burn the protective coating off the mantle.
CAUTION: Do not touch the mantle cloth with the match stick, or mantle may break in use.
Mantle will flare up with a brief flash. Keep combustible materials away. Avoid breathing fumes.
7. Hold the gallery against a firm surface and press the chimney down inside the circle of prongs. After assembly, always
handle the gallery-mantle-chimney assembly as one unit to avoid breakage. For now, set the assembly gallery-mantle-
chimney aside and proceed to Step 8.
CAUTION: Do not use your lamp if the mantle fabric is cracked or broken. Doing so may result in a broken chimney. We
recommend always keeping an extra R150 Lox-On Mantle* on hand.
8. If you are replacing an old burner, remove the old burner from the lamp base. Screw the burner base or basket of
your new burner into the lamp base by turning clockwise. Continue to screw in the burner until it is completely tight and
cannot be turned further.
NOTE: If you purchased an optional shade, screw the burner onto the lamp base through the center hole in the shade
holder.
9. After burner is completely tight, make sure it does not disengage even if over tightened. Make sure the burner cannot
be pulled off without being unscrewed. If you installed the optional shade tripod, make sure the shade tripod does not
wobble.
If burner can come out of base and tips over, or if the shade tripod wobbles, it is a fire and/or burn hazard.
Contact Crownplace Brands and do not use the lamp.
10. Fill the lamp with Aladdin® Fuel or colorless K1 Kerosene. Stop filling when fuel is about ½” from top of reservoir.
CAUTION: Burning the lamp until out of fuel may ruin the wick. (A full tank provides a 10-hour burn. Nightly filling avoids
the risk of having to replace the wick as a result of damage from lack of fuel.)
CAUTION: For best performance, always use fresh fuel. Store fuel and lamp away from sunlight and at room temperature
(to avoid condensation from forming in fuel).
Never refill a hot lamp. Never use gasoline. If you accidentally use any fuel other than Aladdin® Fuel or K1
kerosene, safely remove the fuel to an approved receptacle and replace the wick before using the lamp.
11. Allow the lamp base and burner base assembly to soak for one hour or until the wick is saturated with fuel.
12. Turn wick up 1/8” above the metal edge of the burner’s inner top and light it. Wait a few moments for the flame to
completely cover the top edge of the wick.
Burning off Protective
Coating
To Next Page
Loading...