2 | ADC-CSVR126 Stream Video Recorder Quick Start Guide | 3
LED Reference Guide
Status LED
Blinking
Off
Active
Idle
Network (Tx/Rx) LED
Blinking
Off
Active intranet connection
No active intranet connection
Power LED
On
Off
Powered on
Powered off
Adding the Device to an Alarm.com Account
1 Using an Ethernet cable, connect the device to the network.
2 If you wish to use a display with your SVR, please connect it now
using either an HDMI or VGA cable.
3 Connect the device’s AC power adapter and plug it into a
non-switched outlet.
4 Using the switch on the back of the device, turn on the SVR.
The power LED on the front of the device will illuminte.
Wait 2 minutes for the device to boot up.
5 Add the device to the account by either selecting the account in
MobileTech OR by using a web browser and entering the following URL:
www.alarm.com/addcamera
6 Select the device from the video device list or type in its MAC address
to begin adding the device. The device’s MAC address is located on
the bottom of the device.
7 Follow the on-screen instructions to finish adding the device.
You may associate cameras to the device on the Customer Website.
To Next Page
Loading...
Need help?
General