3
Instructions for operation English
Use box Cube - Code 10010163 - Edition 1 - 12/2005
2) Never use acetone, ammonia or products
containing these substances, as these can
seriously damage the shower box. Similarly,
never use products containing formic acid or
formaldehyde.
3) Floor staves:
To remove any stains from the surface of the
fl oor staves, it is advisable to use plenty of
water and a scrubbing-brush.
4) Tray:
To remove stains from the surface of the
shower tray, it is advisable to smooth using
very fi ne sandpaper and then to clean using
a household abrasive detergent.
The following substances should never
be used: strong acids or alkalines (such
as hydrochloric acid or caustic soda),
chetones (acetone), chlorinated solvents
(trichloroethylene) and other products used
in the paint industry.
5) To remove scale stains from the other surfa-
ces, rub gently with a soft cloth using lemon
juice or vinegar (hot if possible).
AT LEAST ONCE YEARLY
It is not necessary to switch off the water supply
to the shower box in order to clean the fi lter, since
a special internal cut-off device disconnects the
water supply when the fi lter housing is opened.
To remove the fi lter cap, use a coin. If the cap is
diffi cult to remove, a wide fl at-head screwdriver
may be used.
Unscrew the cap completely, remove from the
housing and wash under a tap.
Any scale build-up may be removed by immersing
the fi lter in a solution of water and vinegar for 3
to 4 hours. Alternatively, one of the de-scaling
products commonly used for steam irons or cof-
fee-makers can be used. Follow the instructions
and the concentrations recommended by the
manufacturer of the product used.
Special maintenance
If the surface is seriously damaged, or if damaged
components require replacement, it is necessary
to contact a specialized technician.
The manufacturer recommends that users
contact the nearest authorized service centre
for all maintenance operations.
Important notice to users
1) The appliance must be installed by qualifi ed
personnel in compliance with local and
national safety norms and legislation. The
manufacturer declines all liability for events
arising from incorrect installation or operation
of the shower box.
2) The shower box is designed for indoor use
in bathrooms, and must not be installed in
the open.
3) The manufacturer accepts no liability if the
hydraulic and electrical circuits are not in
compliance with EN safety standards.
The buildingʼs electrical circuit must be in
compliance with EN safety standards and
protected by a standards-approved differen-
tial switch (safety cut-out) with a differential
value of 0.03A. In particular, it is important
to check that the earth connection is effi -
cient and in compliance with the standards.
The power supply cable must be fi xed and
permanently installed, and controlled by
a multi-pole master switch with a contact
gap of at least 3.5 mm. This switch must be
positioned outside the areas marked 0, 1, 2
and 3 (see “Installation Manual”), and as far
as possible from water splashes.
4) Never use or touch electrical appliances
when using the shower box, even when these
appliances are switched off.
5) Electrical appliances positioned in the zones
surrounding the shower box must be securely
fi xed in position to prevent them falling into
the shower box.
6) Children should not be allowed to use the
shower box without supervision.
7) Do not place animals in the shower box when
the hydromassage system is in operation.
8) Do not use the shower box during thunder-
storms.
9) Risks during pregnancy: Pregnant women
and very small children should use the
appliance only with the consent of a physi-
cian.
10) This product is guaranteed as described on
the certifi cate of warranty.
Cleaning the fi lters
(shower boxes
with thermostatic
controls)
5
6
To Next Page
Loading...