Alcad ST-100 User Manual

Technote 6: Setting up ST-100 Terrestrial IP Streamers
DVB-T to IP streaming equipment (ST-series) broadcasts multicast streams and TV/radio
channels, selected from a DVB-T multiplex (maximum 8), from digital terrestrial reception, over
a TCP-IP network. TV services broadcast as IPTV streams can be viewed on an individual
IPTV receiver or by using video reproduction software. The ST modules are configured via
TCP/IP, using either the HTTP protocol (web browser) or TELNET (virtual terminal).
IMPORTANT: It is possible to connect up to 9 ST- 100 modules and 7 ST-110
modules per power supply unit. Each ST module can handle up to 8 MPEG streams; the
IP broadcast, therefore, consists of 8 TV/radio services per module.
IMPORTANT: Layout of the modules must be as shown above. Power Supply (FA-
310/312) must be located on the far left hand side and Terrestrial IP streamer must be the next
module in the chain. Please look at the above picture.
Ensure the following prior to programming:
• It is necessary to connect all the modules to the support frame SP-226 (code 9120130)
for the system to function.
• It is also recommended that you make the earth connection to the building using a cable
with a section of at least 4 mm.
• Power supply/Control cable must be plugged into each module. DO NOT ADD OR
REMOVE modules without disconnecting mains supply power from wall outlet. Always
disconnect the equipment, and then reconnect it to the mains supply. Failure to do so
can cause equipment to fail.
Power Supply
Automatic power Injection
for masthead amplification

Alcad ST-100 Specifications

General

Brand	Alcad
Model	ST-100
Category	Media Player
Language	English

Summary

Technote 6: Setting up ST-100 Terrestrial IP Streamers

Specifications and Initial Setup

Module Specifications

Lists technical specifications for the ST-100 Terrestrial IP Streamers.

Initial Programming and IP Configuration

Guides initial programming and setting up IP addresses for ST modules.

ALCAD IPTV Web Interface Usage

Accessing the Interface

Details how to access the ALCAD IPTV graphical user interface via a web browser.

Interface Navigation Structure

Explains the main navigation menu and configuration bar with sub-menus.

Module Status and Monitoring

Streamer Status

Displays the operational status of the ST module and selected services.

DVB-T NIM Status

Shows DVB-T input tuner data, signal levels, and quality.

Network Status

Displays programmed network data, including IP address and gateway.

Log Status

Provides a log of timed events and incident messages from the ST module.

Core Configuration Settings

Network Configuration

Configures network settings, including IP address, subnet mask, and gateway.

DVB-T NIM Configuration

Sets up input carrier frequencies, bandwidth, and offset for DVB-T signals.

Output Stream and Service Selection

Selects TV/radio services for TCP/IP broadcast and configures multicast.

Advanced Operations and Utilities

SAP Management

Manages Service Announcement Protocol (SAP) for multicast session info.

Streaming Control

Controls the streaming state (Start/Stop) and monitors the streamer's status.

Maintenance and System Utilities

Covers firmware updates, configuration backups, and module utilities.

System Management and Reference

System Log Configuration

Configures incident message forwarding to a syslog server.

Password Management

Allows changing the username and password for module access.

Reference Information

Includes frequency tables and a glossary of acronyms.