SDSL unit failure
...................................................................................................................................................................................................................................
Alarm identifier
SDSLcUPF
Information The SHDSL extension board (X12SDSL) is defective
Alarm category Equipment
ASAP sdsl
Alarm severity
(default setting)
Prompt
Reporting state
(default setting)
Reported
Local indications The red “Fault” LED is lit.
Cause A hardware failure of the SHDSL extension board has been detected.
Actions Replace the SHDSL extension board.
Note(s) As 1643 AM and 1643 AMS systems do not support hardware protection,
SDSLcEQF, and SDSLcUPF are always reported simultaneously as a reminder
that a hardware failure is service affecting.
Alarm messages
...................................................................................................................................................................................................................................
365-312-803R7.2
Issue 4, May 2007
Alcatel-Lucent - Proprietary
See notice on first page
1-131
To Next Page
Loading...
