STM-1 MS Protection switching protocol failure
...................................................................................................................................................................................................................................
Alarm identifier MS1cFOP
Information STM-1 multiplex section automatic protection switching (APS) protocol failure.
Alarm category Processing error
ASAP sdhMSP
Alarm severity
(default setting)
Deferred
Reporting state
(default setting)
Reported
Local indications The red fault LED is lit.
Cause Unstable APS protocol.
Actions Check that the MSP group is correctly created at both ends of the line (both
ends provisioned with the same MSP configuration).
Check that interworking between the two MSP groups is possible.
Alarm messages
...................................................................................................................................................................................................................................
365-312-803R7.2
Issue 4, May 2007
Alcatel-Lucent - Proprietary
See notice on first page
1-181
To Next Page
Loading...
