VC-11 Payload mismatch
...................................................................................................................................................................................................................................
Alarm identifier
VC11cPLM
Information The received V5 signal label, used to indicate the composition of the VC-11
payload, does not match the expected value.
Alarm category Transmission
ASAP sdhLOPath
Alarm severity
(default setting)
Prompt
Reporting state
(default setting)
Reported
Local indications –
Cause The payload composition of the VC-11 is not as expected.
Actions If the received V5 signal label (V5 [5-7]) has a value other than “000” or
“001”, then check if the mapping mode of the local and far-end nodes is the
same.
Note(s) When defining or changing a cross-connection this alarm will almost inevitably
come up as it is practically impossible to issue the changes at both sides at the
same moment.
In the reporting Network Element:
• In the upstream direction VC-11 Remote Defect Indicator (RDI) is inserted.
• In the downstream direction the alarm indication signal is inserted.
Alarm messages
...................................................................................................................................................................................................................................
1-222
Alcatel-Lucent - Proprietary
See notice on first page
365-312-803R7.2
Issue 4, May 2007
To Next Page
Loading...
