EasyManua.ls Logo

Alcatel-Lucent 1643 AMS - DCN addresses

Alcatel-Lucent 1643 AMS
324 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
X4IP option card (
TransLAN
®
)
On the 1643 AM / 1643 AMS an Ethernet LAN option board (X4IP) is available
providing four 10/100BASE-T Ethernet interfaces. This option board is based on
TransLAN
®
. When equipped with a TransLAN
®
option board, Alcatel-Lucent SDH
multiplexers can offer 10/100BASE-T Ethernet interfaces.
The LAN interfaces that are supported are 10BASE-T and 100BASE-TX. The numbers
10 and 100 indicate the bit-rate of the LAN, 10 Mbit/s and 100 Mbit/s respectively.
The T or TX indicates the wiring and connector type: Twisted pair wiring with
RJ-45 connectors. The actual LAN speed does not need to be configured, since the
Ethernet interfaces support the auto-negotiation protocol, which enables them to select
the proper LAN speed automatically. The auto-negotiation function on the TransLAN
®
board is configurable per LAN port. This feature allows the auto-negotiation function
to be manually overridden from the Lucent OMS or the ITM-CIT. If this
auto-negotiation function is disabled, it is possible to select a specific operational mode
(10 or 100BASE-T, Half/Full-Duplex).
The X4IP option card supports Enhanced Flow Classification - IEEE 802.1Q mode and
IEEE 801.2ad mode. Network traffic from end users can be classified into flow
categories on the edge ports of a TransLAN® domain. As a result, ports can be
provisioned as “Edge” or “Interior” ports. Edge ports are either Customer Role ports
(UNI) or “Virtual ports” on a Trunk port (E-NNI). A virtual port is the traffic over a
trunk port belonging to a single end-user and is characterized by an S-VID tag.
On edge ports, up to seven provisionable flows can be defined with a combination of
the following criteria:
port
C-Tag (C-VID, C-UP) previously known as: VID, UP
IP-TOS field (DSCP)
Destination Address Mask (for broadcast/multicast and for customer control traffic)
Ethernet Device
Mapper
SDRAM
Octal
PHY
8*
SMII
8*
10/100BASE-T
Inventory
EEPROM
LEDs
P2
Connector
Power
Module
Main
Board
Product description
Option cards
...................................................................................................................................................................................................................................
365-312-801R7.2
Issue 3, May 2007
Alcatel-Lucent - Proprietary
See notice on first page
4-21

Table of Contents

Other manuals for Alcatel-Lucent 1643 AMS

Related product manuals