Operations Overview
...................................................................................................................................................................................................................................
Operations interfaces and administration
The 1643 AM / 1643 AMS are configured for remote and local operations management
via the Lucent Optical Management Solution and SNMP management solution. Remote
management can be realized via the STM-1 or STM-4 DCC and the Lucent OMS or
ITM-CIT software.
1643 AM / 1643 AMS is configured for remote and local operations management via
the Lucent Optical Management Solution. Remote management can be realized via the
STM-1 DCC and the Lucent OMS or locally via ITM-CIT.
Local connection is available via an RJ45 socket on the main board to connect a PC
loaded with the ITM-CIT software.
Management access features include:
• Simultaneous access by the element management system and local workstations
• Remote access to other 1643 AM / 1643 AMS in the same network by ITM-CIT
• NE level security via three password controlled authorization levels: ADMIN,
CONFIGURE and VIEW.
Maintenance supervision
Transmission and equipment fault supervision is monitored remotely via the Lucent
OMS and locally via LEDs on the unit and via the ITM-CIT. The local ITM-CIT may
also be used to remotely access other 1643 AM / 1643 AMS nodes in the same
network.
Alarm and port termination monitoring features include:
• Physical port provisioning of STM-1 or STM-4 aggregate, STM-1 tributary, E1, E3,
DS1, DS3, SHDSL, X.21 and Ethernet ports in three different modes: automatic
(AUTO), monitored (MON), or non-monitored (NMON)
• VCx (x=11,12,3,4) and P12 (egress) path termination point provisioning in either
the MON or NMON mode
• Alarm severity levels of PROMPT, DEFERRED and INFORMATION
provisionable for each alarm type by provisioning the alarm severity assignment
profile (ASAP)
• The user can assign an alarm message and severity to each MDI (miscellaneous
discrete input) by provisioning the alarm severity assignment profile (ASAP).
Failure reporting features:
• Failure reports are generated for equipment, configuration and software faults with
sufficient information to identify the next step in the fault correction process
• Alarm forwarding to the remote EMS (Element Management System) is supported
via Lucent OMS (LAN-10BaseT) and to the local workstation via the F-interface
(ITM-CIT)
Operations, Administration, Maintenance and Provisioning
...................................................................................................................................................................................................................................
5-2
Alcatel-Lucent - Proprietary
See notice on first page
365-312-801R7.2
Issue 3, May 2007
To Next Page
Loading...
