Q-LAN interface (OMS)
...................................................................................................................................................................................................................................
Purpose
This interface must be used for connecting an OMS management system and using the
“Fast downloading” feature (see Chapter 6, section “Fast download”).
Connector data
The Q-LAN connector is an 8-pin RJ45 connector with metal shell for grounding.
Table 4-8 Pin assignment (Q-LAN cable)
Point on Connector Signal Name Description
1 TX P Transmit-data positive
2 TX N Transmit-data negative
3 RX P Receive-data positive
4 nc Not connected
5 nc Not connected
6 RX N Receive-data negative
7 nc Not connected
8 nc Not connected
Cable data
A standard LAN cable (CAT5) can be used (100 Ω symmetrical).
Cable connection
Please connect the Q-LAN cable as shown in the figure below.
Figure 4-25 Q-LAN connector
1
8
System cabling
...................................................................................................................................................................................................................................
365-312-802R7.2
Issue 4, June 2007
Alcatel-Lucent - Proprietary
See notice on first page
4-25
To Next Page
Loading...
