LAN interfaces (X4IP, X8PL and X5IP card)
...................................................................................................................................................................................................................................
Purpose
Ethernet LAN cables (10/100/1000Base-T) can be connected to these interfaces.
Connector data
The LAN connectors which are located on the X4IP, X8PL and X5IP option cards are
8-pin RJ45 connectors with metal shell for grounding.
Table 4-14 Pin assignment (LAN cables - E/FE)
Point on Connector Signal Name Description
1 TX P Transmit-data positive
2 TX N Transmit-data negative
3 RX P Receive-data positive
4 nc Not connected
5 nc Not connected
6 RX N Receive-data negative
7 nc Not connected
8 nc Not connected
Cable data - GE
The following figure displays the cable desgin for the Gigabit Ethernet (GE) LAN
cable. As GE interfaces are bidirectional, the MDI wiring conforms to the IEEE
802.3-2002 standard. Based on this standard, the MDI-X (cross-over) functions for
bidirectional GE interfaces are not compatible with the MDI-X functions for E/FE
interfaces.
The following figure displays the MDI connector for MDI-X functions and is denoted
with the symbol ’X’.
Figure 4-42 LAN connector
System cabling
...................................................................................................................................................................................................................................
4-42
Alcatel-Lucent - Proprietary
See notice on first page
365-312-802R7.2
Issue 4, June 2007
To Next Page
Loading...
