Aggregate interfaces (Main board)
...................................................................................................................................................................................................................................
Purpose
These interfaces must be used for enabling SDH ring or 1+1 MSP protection (STM-1
only) in point to point applications.
Connector data
The aggregate fiber connectors which are located on the main board are equipped with
SC connectors (AM unit) or LC connectors (AMS unit, SFPs necessary).
Cable data
Single Mode (SM) fibers must be used.
Cable connection
Please connect the aggregate fiber cables as shown in the figure below.
Figure 4-53 Aggregate fiber cables (AM unit)
to ODF (aggregates)
System cabling
...................................................................................................................................................................................................................................
365-312-802R7.2
Issue 4, June 2007
Alcatel-Lucent - Proprietary
See notice on first page
4-55
To Next Page
Loading...
