Result: The desired operation for this slot is performed, and the window
Provisioned NE Components appears again.
...................................................................................................................................................................................................
6
If creating a node, then click Finish. Otherwise, click Close.
Result: The window Provisioned NE Components (or in the case of node creation,
Node Creation - Provision Slots) disappears.
Parameters
Slot
The slot position is given here.
Expected unit
The type of unit provisioned in the listed slot is shown.
Slot state
Displays the status of the listed slot. The different slot states are described in the table
below.
Slot state Description
Assigned Slot is assigned
Unassigned Slot is unassigned
Auto Slot is provisioned but waiting for unit. Once the provisioned
unit is present, the slot state will automatically change to
Assigned.
Operation
When assigning units, an operation must be chosen. The choices are described in the
table below.
Operation Description
Assigned Assigns the unit to the slot.
Unassigned The slot is configured to be empty. The NE will not expect any
unit to be present in this slot.
Auto Automatically assigns the unit to the slot once the NE
establishes the presence of a unit of the correct type. Until this
time, the slot acts as Unassigned.
ITM-CIT installation and NE provisioning
Slot provisioning
....................................................................................................................................................................................................................................
365-312-802R7.2
Issue 4, June 2007
Alcatel-Lucent - Proprietary
See notice on first page
6-21
E ND OF STEPS
...................................................................................................................................................................................................
To Next Page
Loading...
